Mesa Boogie | Mark IIA

Wikipedia Website Link

Mark IIA

Tube Amplifier
Discontinued

Email Sugaree Licks any additions or corrections to Versions

The Mark II introduced channel footswitching. It was not referred to as the “Mark IIA” until the Mark IIB was issued. It was also available as a head (a standalone amplifier), which could be hooked up to a number of different speaker combinations, although a 1×12″ cabinet was the most common. The preamp gain on the Mark IIs occurs after the tone controls and so, according to Mesa/Boogie, the IIA has a “tighter, more focused sound” than the Mark I.[citation needed] The Mark IIA’s control panel was extended from the Mark I’s to include a separate master volume control for the lead mode, and various push/pull switches including Pull Bright, Pull Treble Shift, Pull Gain Boost, a separate Pull Bright for the lead mode, and of course, Pull Lead. The 1/4″ jack previously marked “1” was changed to just “Input,” and “2” was changed to “Foot Switch.” The Mark IIA was a great improvement over the Mark I, however it had a few major flaws that it received criticism for among collectors. The new footswitching system relied on a relay, which made an audible popping noise when switching modes. The reverb circuit was also noise-ridden on some models. The IIA and IIB, and some late-model Mark I amps, used a JFET-based device called fetron in place of the input stage 12AX7 (V1), and included a switch for configuring the amp for either Fetron or 12AX7 operation. The reason for using a fetron was to address some of the problems associated with microphonic 12AX7 tubes in a high-gain situation; its use was later discontinued as newer production tubes were able to withstand the extreme conditions within the amplifier.